Dan-dugan-sound-design E Instrukcja Użytkownika Strona 9

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 48
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 8
Dugan Model E User Guide
9
Chapter 2: Quickstart
This section provides step-by-step instructions to help you get started quickly. It includes
information to connect and install the Model E, make initial settings, and link units.
Step 1 Connections
Connect the provided power supply to the Model E.
Set the NORM-SLAVE switch on the rear panel to NORM (up) for normal (not linked)
operation.
The Model E can be interfaced with:
an analog mixing board;
a digital mixing board using analog or digital connections;
Analog
The Model E is a line-level device normally patched into the insert jacks (send and re-
turn) for each mic input channel on the board. Check the insert jack wiring on your mix-
ing board. If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS
insert cables to connect the Model E. Other configurations require special cables. The
Model E is wired as follows: tip = input, ring = output.
Figure 2-1 Analog connection
Przeglądanie stron 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag